Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Mending fabricator power wires doesn't power it
#1
If you hack a fabricator, when you cut the power wire accidentally and then mend it, it stays off.
confused
#2
I believe you have to mend it, then pulse it with a multitool to jumpstart the thing.
#3
But that doesn't make any sense, pulsing the wire is supposed to kill power for 30 seconds.
#4
Isn't that only on doors? I can't test this at the moment, can somebody who is able check this?
#5
Pulsing the wire won't restore power nor cut it for any amount of time on the fabricators.
#6
The fact mending restores power on everything with wires, just for consistencies sake should do it on the autolathes/fabs too.
#7
The only way I could get a fab to reset when I tried last was to hack the APC and flip the breakers on and off. Egh.


Forum Jump:


Users browsing this thread: 1 Guest(s)