+- Goonstation Forums (https://forum.ss13.co)
+-- Forum: Discussion (https://forum.ss13.co/forumdisplay.php?fid=6)
+--- Forum: Bug Reports (https://forum.ss13.co/forumdisplay.php?fid=9)
+---- Forum: Resolved (https://forum.ss13.co/forumdisplay.php?fid=16)
+---- Thread: Mending fabricator power wires doesn't power it (/showthread.php?tid=5423)
Mending fabricator power wires doesn't power it - somepotato - 09-14-2015
If you hack a fabricator, when you cut the power wire accidentally and then mend it, it stays off.
Re: Mending fabricator power wires doesn't power it - BlackPhoenix - 09-15-2015
I believe you have to mend it, then pulse it with a multitool to jumpstart the thing.
Re: Mending fabricator power wires doesn't power it - Dabir - 09-15-2015
But that doesn't make any sense, pulsing the wire is supposed to kill power for 30 seconds.
Re: Mending fabricator power wires doesn't power it - BlackPhoenix - 09-15-2015
Isn't that only on doors? I can't test this at the moment, can somebody who is able check this?
Re: Mending fabricator power wires doesn't power it - somepotato - 09-15-2015
Pulsing the wire won't restore power nor cut it for any amount of time on the fabricators.
Re: Mending fabricator power wires doesn't power it - somepotato - 09-15-2015
The fact mending restores power on everything with wires, just for consistencies sake should do it on the autolathes/fabs too.
Re: Mending fabricator power wires doesn't power it - Vitatroll - 09-15-2015
The only way I could get a fab to reset when I tried last was to hack the APC and flip the breakers on and off. Egh.