Goonhub
01-05-2017, 06:53 AM
(This post was last modified: 01-05-2017, 06:54 AM by Mordent. Edited 1 time in total.)
When making metal sheets etc. in a fabricator, it currently creates individual sheets. To stack these at the moment requires manually adding each one to a stack (to a limit of 50).
Material sheets, rods, floor tiles, and probably a few other things could massively benefit from being able to be stacked in the same way as ores (i.e. drag one to an adjacent tile to form a stack).
Rods/floor tiles probably aren't as important, as they're created in bulk from metal sheets and so tend to be in stacks already, but I see no harm in doing this as well. Note that this shouldn't allow different types of materials to be combined into one stack.
Material sheets, rods, floor tiles, and probably a few other things could massively benefit from being able to be stacked in the same way as ores (i.e. drag one to an adjacent tile to form a stack).
Rods/floor tiles probably aren't as important, as they're created in bulk from metal sheets and so tend to be in stacks already, but I see no harm in doing this as well. Note that this shouldn't allow different types of materials to be combined into one stack.