Goonstation Forums › Discussion › Ideas & Suggestions
"Dead man's switch" assembly

Thread Rating:
  • 3 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
"Dead man's switch" assembly
aft2001 Offline
Mentor
Posts: 1,398
Threads: 116
Joined: Sep 2016
BYOND Username: Aft2001
#7
02-01-2019, 12:19 PM
I think a simple way to implement this would just be a feature on the proximity sensor to invert detection - basically just send a signal when the last person leaves its designated range
Find
Reply


Messages In This Thread
RE: "Dead man's switch" assembly - by The Gorog - 02-01-2019, 08:31 AM
RE: "Dead man's switch" assembly - by Wisecrack34 - 02-01-2019, 10:33 AM
RE: "Dead man's switch" assembly - by Vitatroll - 02-01-2019, 11:24 AM
RE: "Dead man's switch" assembly - by aft2001 - 02-01-2019, 12:19 PM
RE: "Dead man's switch" assembly - by The Gorog - 02-01-2019, 12:55 PM
RE: "Dead man's switch" assembly - by Kovirii - 02-20-2019, 12:16 PM
RE: "Dead man's switch" assembly - by Firebarrage - 02-22-2019, 02:45 PM
RE: "Dead man's switch" assembly - by The Gorog - 02-22-2019, 11:20 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)