03-21-2017, 09:14 AM
(This post was last modified: 03-21-2017, 09:15 AM by atamusvaleo. Edited 1 time in total.)
I started on a pallet jack and pallets to accompany them but I'm running into an issue... the crates are so large already that this barely leaves room within the 32x32 zone to create the jack.
Two part question for the coders.
Part 1: Is it possible to have a set stack location that is offset from the objects normal location?
Part 2: Would it be possible to multiple stack locations as you add objects?
(I'll edit in photos to demonstrate my point later on)
Two part question for the coders.
Part 1: Is it possible to have a set stack location that is offset from the objects normal location?
Part 2: Would it be possible to multiple stack locations as you add objects?
(I'll edit in photos to demonstrate my point later on)