Goonhub
07-08-2016, 05:42 PM
(This post was last modified: 07-08-2016, 08:09 PM by Musketman12. Edited 1 time in total.)
(07-08-2016, 01:42 PM)Vitatroll Wrote: Sometimes the atmos bug bugs out. You can generally tell this is happening after orange or too much white shows up in your burn after 10 minutes or so. I used to start my burns by:
- wrench cans
- activate mixer, standard pressure, 66/33 oxy/plas.
- open the vent
- go in and igniting the gas by standing on the outlet and using the RCD sparks
- pop the hole up top
- go back and drop mixer to 50kPa for snazzy one tile burn
Now this just tends to create a bugged burn.
The one thing I can say to all aspiring hellburners and even the 'pros' out there - always start the burn first. It's the most important thing to do, and the sooner you get it done, the more power potential your setup has.
Ok so I tried this, it worked and got me up to around 30 MW's but then the pipes burst and everything burst into flames and the engine dropped to no power.
I tried again the next round and this time I RCD'D the floor under the canisters and it worked, got my first hellburn, currently at 200 EW right now