Goonhub
07-08-2016, 01:42 PM
(This post was last modified: 07-08-2016, 01:45 PM by Vitatroll. Edited 2 times in total.
Edit Reason: I forgot how I used to set it up
)
Sometimes the atmos bug bugs out. You can generally tell this is happening after orange or too much white shows up in your burn after 10 minutes or so. I used to start my burns by:
- wrench cans
- activate mixer, standard pressure, 66/33 oxy/plas.
- open the vent
- go in and igniting the gas by standing on the outlet and using the RCD sparks
- pop the hole up top
- go back and drop mixer to 50kPa for snazzy one tile burn
Now this just tends to create a bugged burn.
The one thing I can say to all aspiring hellburners and even the 'pros' out there - always start the burn first. It's the most important thing to do, and the sooner you get it done, the more power potential your setup has.
- wrench cans
- activate mixer, standard pressure, 66/33 oxy/plas.
- open the vent
- go in and igniting the gas by standing on the outlet and using the RCD sparks
- pop the hole up top
- go back and drop mixer to 50kPa for snazzy one tile burn
Now this just tends to create a bugged burn.
The one thing I can say to all aspiring hellburners and even the 'pros' out there - always start the burn first. It's the most important thing to do, and the sooner you get it done, the more power potential your setup has.