Thread Rating:
  • 2 Vote(s) - 3.5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How to Engine
#11
Here is my super !!FUN!! engine setup that easily gets to TW+
  • Attach two plasma canisters to the cold loop.
  • Attach two plasma canisters to the hot loop.
  • Attach one plasma, and one oxygen canister to the mixing loop.
  • Run over to the Pump Control Computer and set all but the purge vents to OPEN/ON and set their level to 5
  • Run over to the Gas Mixer Control Computer and set the gas mixture to 33 Oxygen 66 Plasma and set the output to 150KpA
  • Turn all cold loop valves open, and allow it to run trough the system, do not forget to open the freezer bypass valve(s)
  • Turn the combustion chamber pipes open, and slowly start building a fire.
  • After roughly one to two minutes, open the vent and grab the RCD.
  • Use the RCD to open one of the tiles with a red dot on it. http://i.imgur.com/7WzsjDE.png
  • Once the combustion chamber looks hot, open the hot loop valves and allow it to heat the plasma.
Small notes:
  • See a pipe burst? That's normal! It wont affect the burn in any way!
  • Removing the tiles under and around canisters will allow them to live longer, try it!
  • Never use OXYGEN or NITROGEN inside the hot or cold loop.
  • Enable the PTL once you are above 100MW for maximum $$$$
Reply


Messages In This Thread

Forum Jump:


Users browsing this thread: 1 Guest(s)