12-06-2015, 05:32 AM
Quote:This setup should reach up to, and above `120GW` within 30 minutes.
Requirements:
- Four plasma canisters.
- One N2O canister.
- One Oxygen canister.
- One RCD.
- One space or fire suit.
- Prepare the cold loop by inserting two plasma canisters, and one n2o canister on the cold loop ports.
- Turn on the freezers, and set them to the lowest possible setting, then open all cold loop valves.
- Set all pump speeds to 1 using the pump control computer and disable one of the combustion chamber pumps.
- Obtain TWO tanks of normal 33/66 plasma & oxygen fuel mixture, attach those to the combustion chamber ports.
- Get a RCD and remove the flooring under ALL canisters.
- Remove ALL fuel tanks, from the engine and control room, to prevent explosions.
- Open the combustion chamber vent.
- Open both valves on the combustion chamber loop.
- Important: Only ONE pump should be running, otherwise we would be wasting fuel.
- Ignite the combustion chamber, and close the heat shield.
- Important: keep this CLOSED otherwise the glass will break, setting you and others on fire!
- After rougly five to ten minutes you can open all hot loop valvesand allow plasma to flow through the pipes, experiment with the amount of plasma you allow to flow through the hot loop!