Thread Rating:
  • 2 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Donk Pocket change.
#2
(08-22-2021, 02:54 AM)RGBDeadSilent Wrote: Donk pocket change just hit, I can't find a github log about it, so i'm posting here.

Currently if you overheat a donk pocket past a certain temperature, it turns into a Scalding donk. This means, generally, the only way to heat a donk pocket is via the Microwave, the oven on 1s Low, or... The Strelka prismatic laser?

When a Donk pocket is A Scalding Donk pocket, it stays like that for a certain period of time, consuming it gives you 10u of ????.
After roughly 5m, you'd think the Scalding Donk would cool down, and you would have a Warm Donk, but you instead get... a normal Donk?

Bug Report!
Current Behavior.
Super heat Donk Pocket.
Turns into Scalding Donk Pocket.
Cools down into Donk Pocket.

Expected Behavior.
Super heat Donk Pocket.
Turns into Scalding Donk Pocket.
Cools down into Warm Donk Pocket.
Cools down into Donk Pocket.

Opinion and Suggestion.
So that you don't have folks super heating donks, and then letting them cooldown and possibly be used while they are fighting, add a new Donk. Donk Pocket -> Warm Donk Pocket. If it cools down, it show up as just Donk Pocket, but if heated again, it becomes Re-Heated Donk Pocket. Giving only 5u of Omnizine.

the reason why you can't find the github log about is due to the fact that the person who made it did not give a poll for it
Reply


Messages In This Thread
Donk Pocket change. - by RGBDeadSilent - 08-22-2021, 02:54 AM
RE: Donk Pocket change. - by Sanngrior - 08-22-2021, 10:07 AM
RE: Donk Pocket change. - by THISISANICEGAME - 08-22-2021, 07:12 PM
RE: Donk Pocket change. - by Katzen - 08-23-2021, 01:48 AM
RE: Donk Pocket change. - by RGBDeadSilent - 08-23-2021, 11:29 AM
RE: Donk Pocket change. - by THISISANICEGAME - 08-23-2021, 01:27 PM
RE: Donk Pocket change. - by unfunnyperson - 08-23-2021, 03:31 PM
RE: Donk Pocket change. - by RGBDeadSilent - 08-23-2021, 05:03 PM
RE: Donk Pocket change. - by Zafhset - 08-23-2021, 08:06 PM

Forum Jump:


Users browsing this thread: 3 Guest(s)