Goonhub
10-23-2020, 02:56 PM
(This post was last modified: 10-23-2020, 02:57 PM by Frank_Stein. Edited 1 time in total.)
One thing you could do for harder doors is just require more than one wire to be cut for the power to cut
Or, require a combination of some that need to be cut and others intact
Make the multitool more like a volt meter, in that it can tell you how much power is going through a wire and what it is likely powering based on that
Or, require a combination of some that need to be cut and others intact
Make the multitool more like a volt meter, in that it can tell you how much power is going through a wire and what it is likely powering based on that