Goonhub
09-13-2020, 02:32 PM
Assuming that you put the first glove on touching only the edge/bottom of the glove, and then putting the other glove on using the first glove, you don't leave a lot of room to leave prints.
Also as it is now, I don't 100% support this, but I think it would be good to have these on the black leather/fiber gloves that most of engineering gets because a lot of people wear those and it can be difficult figuring out who has what with those, a lot more than insuls. I'm also mostly certain that latex gloves already give partial ID, so why change them to material only? Seems a little bit counter to the point to me.
Also as it is now, I don't 100% support this, but I think it would be good to have these on the black leather/fiber gloves that most of engineering gets because a lot of people wear those and it can be difficult figuring out who has what with those, a lot more than insuls. I'm also mostly certain that latex gloves already give partial ID, so why change them to material only? Seems a little bit counter to the point to me.