Thread Rating:
  • 6 Vote(s) - 2.33 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Make utility belts printable?
#12
(03-11-2020, 08:51 PM)Studenterhue Wrote: There some brief discussion of this idea in general admin chat, with most people being against the idea. One of the proposals floating around was to add a delay for taking something out of a belt or backpack during combat.

Please no. It's bad enough some weapons are one hit is certain doom (see C-saber and OHR/Derringer) and it can be seconds between you hacking a door open and dying, doing that would only make this worse, and make security's job a whole lot worse than the job of most any antags.

As for belts, they're in a good spot right now IMO, making them accessible to every greytider or antag is a bad idea. To put into perspective how bad it can be... You can hold all the tools you need to get in to any where and still hold a c-saber or EMAG or something. You could carry stims, c-saber, meds, and various other things in even a wrestling belt, which is very powerful.
Reply


Messages In This Thread
Make utility belts printable? - by Dickles - 03-11-2020, 06:07 PM
RE: Make utility belts printable? - by aft2001 - 03-11-2020, 06:09 PM
RE: Make utility belts printable? - by DasBrain - 03-11-2020, 07:28 PM
RE: Make utility belts printable? - by aft2001 - 03-11-2020, 07:33 PM
RE: Make utility belts printable? - by Dickles - 03-11-2020, 10:18 PM
RE: Make utility belts printable? - by aft2001 - 03-12-2020, 04:08 AM
RE: Make utility belts printable? - by Leeanei - 03-12-2020, 06:26 AM
RE: Make utility belts printable? - by Drago156 - 03-12-2020, 06:34 AM
RE: Make utility belts printable? - by KikiMofo - 03-12-2020, 09:22 AM
RE: Make utility belts printable? - by BLooDHoG - 03-12-2020, 10:20 AM
RE: Make utility belts printable? - by Technature - 03-13-2020, 09:26 AM
RE: Make utility belts printable? - by KikiMofo - 03-13-2020, 11:06 AM
RE: Make utility belts printable? - by Technature - 03-13-2020, 01:33 PM
RE: Make utility belts printable? - by KikiMofo - 03-13-2020, 06:15 PM

Forum Jump:


Users browsing this thread: 3 Guest(s)