Thread Rating:
  • 3 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
"Dead man's switch" assembly
#8
(02-01-2019, 12:19 PM)aft2001 Wrote: I think a simple way to implement this would just be a feature on the proximity sensor to invert detection - basically just send a signal when the last person leaves its designated range

Not quite the same as having to hold it in hand, but I wondered if having this as a 2nd new option would make any sense.
Reply


Messages In This Thread
RE: "Dead man's switch" assembly - by The Gorog - 02-01-2019, 08:31 AM
RE: "Dead man's switch" assembly - by Wisecrack34 - 02-01-2019, 10:33 AM
RE: "Dead man's switch" assembly - by Vitatroll - 02-01-2019, 11:24 AM
RE: "Dead man's switch" assembly - by aft2001 - 02-01-2019, 12:19 PM
RE: "Dead man's switch" assembly - by The Gorog - 02-01-2019, 12:55 PM
RE: "Dead man's switch" assembly - by Kovirii - 02-20-2019, 12:16 PM
RE: "Dead man's switch" assembly - by Firebarrage - 02-22-2019, 02:45 PM
RE: "Dead man's switch" assembly - by The Gorog - 02-22-2019, 11:20 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)