Goonhub
05-14-2013, 02:55 PM
I think something like http://www.youtube.com/watch?v=n1wV3lmbSv4 would be pretty neat for a zipgun.
Requires two seperate pieces that could be combined together, fired, then taken apart to be reloaded if it doesn't explode.
Also I think the liberator (3d printed gun) requires that you use acetone to bore out the barrel to reduce friction, so maybe chemistry could be required to make the gun less terrible.
Requires two seperate pieces that could be combined together, fired, then taken apart to be reloaded if it doesn't explode.
Also I think the liberator (3d printed gun) requires that you use acetone to bore out the barrel to reduce friction, so maybe chemistry could be required to make the gun less terrible.