Buff Chemicompiler heating rate + a few additions - Printable Version +- Goonstation Forums (https://forum.ss13.co) +-- Forum: Discussion (https://forum.ss13.co/forumdisplay.php?fid=6) +--- Forum: Ideas & Suggestions (https://forum.ss13.co/forumdisplay.php?fid=8) +--- Thread: Buff Chemicompiler heating rate + a few additions (/showthread.php?tid=3921) |
Buff Chemicompiler heating rate + a few additions - TDHooligan - 01-03-2015 The chemicompiler takes a very long time to heat up beakers meaningfully, perhaps up the speed? Also, some extra commands similar to + and - but with larger increments to help this? Perhaps 5/10/50 increments would be nice. I've got upwards of 100 +s in one function. Re: Buff Chemicompiler heating rate + a few additions - FishDance - 01-03-2015 If you have one hundred +'s in a script then you're not multiplying, try looking for ways to optimize your code. I'm definitely saying no to the increments, it would be nice but it removes some of the magic. As for heating rate, it would be nice, but at the same time you can just preheat beakers, so it's not all that necessary. I think the thing works fine as it is. Re: Buff Chemicompiler heating rate + a few additions - UrsulaMejor - 01-03-2015 the heating rate uses the same proc as the reagent heater/cooler, I think, so a buff really isn't necessary? you just can't set it to 1000 to heat something to 700, which is why you think it's slow. Re: Buff Chemicompiler heating rate + a few additions - TDHooligan - 01-04-2015 Perhaps that could be changed then? If I recall from my experience it can take up to a minute to heat something a hundred or so degrees; of course it may just be lag. |